Need Help!! Blater idles But when i push the throttle it dies!!
#1
Need Help!! Blater idles But when i push the throttle it dies!!
I put a 2003 motor in my 1998 blaster. I grounded the extra green wire from the new motor and the quad starts right up but only idles. And when i disconnect the TOR box it shuts off too. I cleaned the carb, put in a new plug, and still nothing. Any kind of help would be greatly appreciated!!
#4
Yeah,.... it's not talking to the right circuit, so the CDI probably thinks it's got a short or an open that's not supposed to be there when in normal riding operation. The TORS system is a PITA when everything goes wrong.
As Stated above, if you're using the engine and CDI and all the correct electronics, you need to tie the 2 wires together, otherwise the CDI doesn't like it. Limits the Rev's or Kills it.
As Stated above, if you're using the engine and CDI and all the correct electronics, you need to tie the 2 wires together, otherwise the CDI doesn't like it. Limits the Rev's or Kills it.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)