07 BigBear 400
#1
#2
in my 350 i just took a chisel to them. you dont need a puller. take a hammer, lots of wd40 and a chisel and they should come right out. two on mine were rusted so bad they werent even turning and i still got them out. it doesent even matter if you bust them getting them out. just whatever works best. be sure to pack the new bearings with lots of grease.
#5
I agree - pop the bearings in the freezer for a day, they go in easier. I also too a big fender washer and grinded it down to the OD of the bearing (55mm) and used that to help wack in the new ones! Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
yamahabigbear4004x4
Yamaha
6
01-26-2005 04:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)