$300.00 brand new. Would the extra few mm make enough difference in performance to make it worth it on my bike? I think it should be a bolt on mod. Yes or no.

 

What you need to do is check and see if the floatbowl has a lower drain than the stock one because if it is too low it will hit the starter. For the most part it will be a bolt on mod if you dont have to change the throttle cable but you will probably have to change the jetting. what is the 36mm bsr off of? I think I am going to try and get a used yz125 or yz250 carb to put on mine, I will probably have to mod the float bowl to clear the starter. And change jetting to get the a/f mix right.

 

It's the factory Raptor 350 carb it even comes with a 142.5 main jet and it's set up for a thumb throttle. I'm just not sure it will make much of a difference.

 

not sure if you try it out though let me know

 

that carb has the same throttle cable housing and the same fuel bowl as the 33mm carb on the wolverine. only thing i have not checked it to see if were the hoses clamp to it are the same size. I bouhgt a 36mm BSR off a LTZ400 and the main body is the same but the throttle housing and the float bowl are completey different