You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the ATVConnection Forums community today!
Have an oldie... 1989 Big Boss. It uses a caliper to grab the transmission... Took off the caliper to inspect nd the piston is stuck all the way in. Brake fluid comes out the line when pumped... but not near enough force to move the piston out. Looking for any and all suggestions... Have heard of compressed air... Thanks for any help.
welcome to the forum. sounds like the piston is rusted into the caliper. chances are you'll find a ring of rust near the very outside edge of where they meet in which it will always leak if you try to clean it up when you get it apart. had the samee isue w/ my car and couldn't find a rebuild kit(and i doubt polaris has on either) so i had to replace the whole caliper. you might be able to use compressed air if you have enough pressure and a good seal to force air into it. i had to use a pry device to get it back enough off the disk. good luck.
Caliper seal/piston rebuild kit #1930666 for transmission brake, kit #1930665 for front brakes are still available as long as the calipers aren't corroded inside,and need replacement as mentioned. OPT
Retired and loving it! (Main job now,wake up the wife to go to work!)
92 Honda Night Hawk 750 (5500 actual miles)
2000 Chevy Silverado 1500 Sport side (268,000 miles,semi retired)
Whats right is whats left after you do everything else wrong (Robin Williams)
Don't pick a fight with an old man,if he can't fight he'll just shoot ya!