Update on my problem:
Purchased a fuel pressure tester to check PSI. Machine was pumping out 10PSI. I understand that they are supposed to pump out 40psi +/-3. Either way I was well below that mark. So today I replaced the pump with an Airtex pump #E8198 and strainer sock #FS111. Hooked wire and line back up to pump and poured fresh gas back in the tank. Turned key on an off a few times to get some gas circulating, heard pump pulling gas which wasn't happening with old pump. Hooked up pressure tester to fuel rail and still only pushing 20psi. Took it for a spin and same problems are still occuring. Could replacing my fuel filter bring pressure up 20psi?
My wheeler, like Helmethair78's, also will not go over 30mph so that makes me wonder if my coil may also be bad. Any suggestions or pointers would be greatly appreciated. Thanks.
|