Clutch removal??????

[mikesgood4u]

I removed the center bolt and slid a 6" 3/8's extention into the hole that the bolt came out of and I have tapped it several time, I have even sprayed pb blaster into it.... still not comming off.... and sugestions??

[ZAKAZIM]

There is a polaris puller you have to have to do this. I got my puller off Ebay.


http://cgi.ebay.com/ebaymotors...Q5fPartsQ5fAccessories

[stendori]

<div class="FTQUOTE"><begin quote>Originally posted by: mikesgood4u

I removed the center bolt and slid a 6" 3/8's extention into the hole that the bolt came out of and I have tapped it several time, I have even sprayed pb blaster into it.... still not comming off.... and sugestions??</end quote></div>

you need a clutch puller that goes into the center where you took the bolt out. it WILL NOT come off any othr way w/ out damaging the clutch.

[teamplayer]

If you are handy, you can make your own puller with 9" long piece of 3/4" <u>FINE </u>thread rod and two nuts jamed or welded to the end.

[scrambler400enoge]

When I had my clutches removed by the dealer he used an air drill for the primary,and a slide hammer for the secondary.

[uncertifiedmechanic]

Just the old clutch puller, fat and stubby, after you break the primary off, make sure you use some Emory cloth to clean the cranks shaft up

[eggenz7]

the secondary should just slide right off. its on a coarse splined shaft. very easy to remove. but you will need a puller to get the drive clutch off. whether it be a homemade one or a storebought one. that bolt in the middle is torqued around 50 ft lbs. take that pressure over a couple of heat/cool cycles and its stuck pretty good.

[1greenhornet]

Eggenz7,

I just ordered the secondary clutch buttons and wanted to get some clarification on any special tools I will need to install them.

Anything else I need to check while I have it off?

Thanks,

Scott