When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Polaris Ask an Expert! In fond memory of Old Polaris Tech.An area where experts in their field will answer non-general questions about your Polaris ATV. "old polaris tech" and other experts will answer your questions as they have time.
ASK ALL GENERAL QUESTIONS OR BASIC QUESTIONS IN THE POLARIS FORUM. Basic or General questions posted in a expert section will be moved!
So I have changed the bap sensor fuel pump and filter injectors plugs and checked the wiring harness for the bap sensor and it still wont run. Will barely start and sputters out and dies. Tested the crank sensor and the throttle sensor. No idea where to look next
So I have changed the bap sensor fuel pump and filter injectors plugs and checked the wiring harness for the bap sensor and it still wont run. Will barely start and sputters out and dies. Tested the crank sensor and the throttle sensor. No idea where to look next
Like the manuals say efi problems are caused by wiring issues 80% of the time,not the sensors themselves. Wires may may not always show bare spots,but can have a soft spots,broken internally or even pulled out of the cheap connectors leading to the sensors.I replaced too many Polaris harness kits that continued to fail.Look at the "sticky" post above this section on efi problems. Shows links to this site that addresses the thin wiring/connector problems that are probably the cause of your problem.Better kits are available. T-bab,map sensor wiring was the most common problem on idle problems,back firing etc. Plus codes don't always have to be thrown to show where the problem is,but at times they do. For instance codes,41,42,45 refer to tbap harness short problems. Only The Best