Donald:
Saw a post from years ago that you had wiring diagram for a Honda TRX300 FWD.
Could I get a copy.
Thanks,
Edwin
edwinchisholm@eastlink.ca

Hello are you still active i need some honda help

Thanks so much for your post regarding the shift lever shaft getting frozen. My wife's 04 honda 400 AT lever wasn't going into drive, neutral and reverse as easily as it should have. It was getting stuck/frozen. After reviewing your post I removed the shaft cleaned it up with fine steel wool, oiled it, etc., put it back. It's fine now. Thanks so much. Dennis 703-324-1643

hey i see from posts that you have ignition tests for 1988 trx350. I have no spark , apparently the coil is ok. Is it possible to send me a wiring diagram for this bike and maybe these tests i can do . Thanks

I'm trying to print out your diagram for installation of an angle sensor for 2006 Rancher ES 350 but it won't let me.. What's my problem

Hey I am new to this forum and I was hoping you could email me a wiring diagram for the starter relay for a 04 Polaris Sportsman 400. I forgot to mark the wires. I would appreciate your help!
commonhack@gmail.com
Thanks

i have a 1987 honda 250 for trax and it wont start i beleive its a wiring problem werer should i start lookin

Please help stair me in the right direction by reading my thread (marine tech) I have a 2004 rubicon 500 hondamatic I bought it with the issue. The old man said he swamped it. He drove it home and shut it off. Now the engine runs but doesn't move. I brought to a dealer and they charge me a 100.00 and all they did was start it and remove a screw on the side and said it has no oil pressure. I bought a manual but it doesn't go over that issue.

What's codes and how do I get to the oil pump chain.
I just a new bee looking for advice from the experts please help.

Wow... sounds like your the guy to ask. Well I've got an 05 rancher 350 that won't charge the battery. (new battery and rectifier) With the ground cable off and checking voltage from it to the positive cable it shows around 3 volts from the stator, but when I touch the cable to the battery it doesn't add the voltage to the battery according to my meter?.... I did the same test to another 350 rancher and it added the voltage to the existing battery voltage(12.5) bringing it up to 14.8. why won't this one do the same thing?. Everything seems to be okay...I'm stumped...bad stator? man I hate quessing

just wondering if you can send me the link for 1986-93 TRX350D PDF Honda shop Manual? Please and thanksyou just got it and can't afford much at the moment. Thanks so much in advance

ripper1@execulink.com