LT80 KFX80 carb issues
#1
LT80 KFX80 carb issues
I bought a 2003 KFX80 a few months ago. The **** for the choke was missing. I recently purchased a 1989 LT80 for parts. Both have Mikuni carbs that look identical, but I found that the choke (plunger) assemblies will not interchange (one is smaller than the other where it screws in the carb). Is this due to the year differences? Also, I need the fitting that goes in the side of the carb for the oil line; I'm assuming this is not available by itself, and I will need to find a used or junk carb to get this fitting? Thanks for any info.
#2
Other than pull **** does the carb seem to serve its purpose making the bike run. If it does u could use some hand grip wire to twist in the groove on choke stem and leave a loop to pull with finger or attach wire to something the size of a dime to pull and use to push down the choke stem. Or look at stem size of both carbs pull **** off and put on other with epoxy or super glue so it doesn't fall off that is the cheapest fixes
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)