Rancher with code 5
#1
Rancher with code 5
Hello .I have a 2005 Rancher AT thats flashing a code 5. I"M reading that is the angle sensor. I also have read that it has to be preloaded at installation. Is this information correct? also will I have to clear the code from the ECM after installation ? If so, how is that done ? Thanks for any help!
#2
Here are the tests for code #5 ..
================================================== ===========
================================================== ===========
If you replace the angle sensor this is the pre-load info ...
================================================== ===========
================================================== ===========
This is how to delete stored code/s ..
================================================== ===========
================================================== ===========
Don't forget to initialize the ECM ..
================================================== ===========
================================================== ===========
================================================== ===========
If you replace the angle sensor this is the pre-load info ...
================================================== ===========
================================================== ===========
This is how to delete stored code/s ..
================================================== ===========
================================================== ===========
Don't forget to initialize the ECM ..
================================================== ===========
Thread
Thread Starter
Forum
Replies
Last Post
Sw00p
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
09-24-2015 02:50 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)