bypass safety switches
#1
bypass safety switches
I have a fuxin 110cc. I can get it to turn over rather easily.new plug,carb rebuilt etc etc.
it has the brake master cylinder on each handle for the brakes with the brake safety switches. and I have the pull cord kill switch on the rear.
can I just unplug the rear kill switch an it will be fine?
and on the handle bar brake switch,if I take off the wires,do I leave them open or a jumper wire to make the cdi box read it to start. I think this is my problem with it not starting.
thanks
it has the brake master cylinder on each handle for the brakes with the brake safety switches. and I have the pull cord kill switch on the rear.
can I just unplug the rear kill switch an it will be fine?
and on the handle bar brake switch,if I take off the wires,do I leave them open or a jumper wire to make the cdi box read it to start. I think this is my problem with it not starting.
thanks
#2
#4
Thread
Thread Starter
Forum
Replies
Last Post
fordfaithful21
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
12-07-2015 05:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)