won't turn off now
#1
won't turn off now
I have a 72cc atv with 5 wire cdi, had no spark so I got cdi, coil, stator, sparks now and runs great but it won't turn off, the key, bar kill switch and rear pull string all ground out when used (testing b/w wire at cdi) but the motor doesn't stop. anybody know way ? or can I just put a kill switch in line to coil power wire ?
#3
if all switches are working the something is not grounded properly. Did you check to make sure no pins are backing out of the plug for the cdi? i had that issue before when you plugged it in one of the pins would push out a bit it was hard to see. Have you tried putting the old cdi in to see what happens? if you want to put in a additional kill switch just run one of the battery ground. Take away the ground it should shut off.
#4
if u pull the wire plug off of the cdi plug and OHM the b/w wire to ground all the kill switches work as they should, so if I run a wire from the cdi to a switch and to ground, the motor should stop running? correct? if it doesn't stop the cdi must be bad ? could I just run a 20 amp toggle switch in line with power wire to the coil to kill it? I put the old cdi back in to check out the new cdi and the new stator stopped workin. don't want to spend any more cash on this junk.
#5
#7
Trending Topics
#8
#9
If you can't ground the kill wire out to kill the machine, don't think an added switch would help any. Sounds like you have a bad cdi internal kill wire to begin with,even if it is new. Had the same thing happen on a few Polaris atvs. Some people just changed the cdi out,others just said they'd just choke em down rather than buying a new one.Possible you could run an inline switch to the coil power wire then to ground to kill it,but never did one myself..
#10
Thread
Thread Starter
Forum
Replies
Last Post
MikeyBoyesq
ATV Racing
1
08-10-2015 11:11 AM
ATVC Correspondent
Performance Mods and Project Quads
1
07-30-2015 09:39 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)