Tao Tao 125D keeps blowing fuses!!
#1
Tao Tao 125D keeps blowing fuses!!
Forgive me if this has already been answered but I can't find an answer. Just bought two 125D atvs. One runs fine. We assembled the second one on Wed and it too was fine until yesterday (the next day). Rode it for a few minutes and realized the brake light (maybe tail light?) was lit up and we couldn't get it to turn off. We turned the atv and then it was dead. Found out fuse had blown. Don't mean to sound like an idiot but I can't find anything online that shows a wiring diagram or anything else to help. With that said, the fuse that blew is going to the red wire that goes straight to the battery. I don't know which fuse that is or if this is the only fuse. Don't have a clue what or where the solenoid, regulator, etc are located. I recharged the battery to make sure it was charged, and put it a third fuse. It had power, but nothing happened when I pressed the start button with the brake held in. I then pressed the unlock button on the remote control to see if that was the problem and then the fuse blew again. Please help this city girl!! And don't hesitate in responding to me like I'm a child, I feel like it right about now.
#2
your solenoid is downstream of the battery headed towards the starter. i can't remember exactly on the taotao, but you can follow back up the red wire from the starter to find it. on the brake light being illuminated full time, i bet your brake switch up on the handlebar is stuck. blowing a fuse means something that is powered is going straight to ground. what size fuse is it? at least and no more than a 7 amp, right? you bought this new? what's the return policy? it may have defective wiring, but we won't know for a few days because of testing times. what are your thoughts on this? we can help you out, no problem, it'll just take some time.
#3
when you turned the atv, left or right, i betcha a wire got pinched in the wiring loom bundle in/around the vertical handlebar tube and broke/pinched a wire and killed it. OR, the wire may not have had enough factory slack and pulled loose from the left hand red slider kill switch. check that out also.
#4
#5
Thanks and you're exactly right! A wire was loose in the white box that connects the set of wires. We've got it running now BUT, another strange issue. The foot brake works as in it will stop the atv but when it's pressed, the brake light doesn't come on. Only the hand brake will make the brake light work. Also, the hand brake will allow it to start but the foot brake won't.
#6
Thanks and you're exactly right! A wire was loose in the white box that connects the set of wires. We've got it running now BUT, another strange issue. The foot brake works as in it will stop the atv but when it's pressed, the brake light doesn't come on. Only the hand brake will make the brake light work. Also, the hand brake will allow it to start but the foot brake won't.
#7
Former TaoTao owner
Thanks and you're exactly right! A wire was loose in the white box that connects the set of wires. We've got it running now BUT, another strange issue. The foot brake works as in it will stop the atv but when it's pressed, the brake light doesn't come on. Only the hand brake will make the brake light work. Also, the hand brake will allow it to start but the foot brake won't.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)