GY6 150 CC hard to start and boging down
#1
GY6 150 CC hard to start and boging down
Hello Ya'll
I am hoping one of you fine folks can shine some light on this issue for me. I am working on my neighbors Chinese Wildfire 150cc atv that he bought for his kids.
It was in bad shape when I started. I have replaced the carb, spark plug, coil , ignition switch, and the starter/kill switch on the handlebar. I can get it running after a few attempts. It will run for a bit then quit. If it give it any gas it dies. After it warms up it runs a little better but it will bog down when I give it any throttle. I dont believe it is a vacume leak but at this point I am looking for any ideas.
Thanks In Advance
Have a Quality Day!
I am hoping one of you fine folks can shine some light on this issue for me. I am working on my neighbors Chinese Wildfire 150cc atv that he bought for his kids.
It was in bad shape when I started. I have replaced the carb, spark plug, coil , ignition switch, and the starter/kill switch on the handlebar. I can get it running after a few attempts. It will run for a bit then quit. If it give it any gas it dies. After it warms up it runs a little better but it will bog down when I give it any throttle. I dont believe it is a vacume leak but at this point I am looking for any ideas.
Thanks In Advance
Have a Quality Day!
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
TegraQuad
1) Engine problems..
13
11-26-2017 01:40 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)