200 carb ?
#1
#3
#4
#5
As far as the jets go snug them up but don't overdo it. The pilot screw (air/fuel mixture screw on the underside of the carb) on the other hand, you just screw in until it is LIGHTLY seated and then back off approximately 2 full turns as a good starting point. Then adjust from there.
#7
Trending Topics
#8
I'm not for sure but I just ordered a new one for my 81 honda 200 on amazon for 26 dollars I hope it comes preset lol
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)