belt light blinking
#2
On my 04 and 05 650 V2's, the light would start blinking every 100 hrs as a "Service Belt" reminder. If you had any problems with the belt, the motor would be de-rated and the quad would run at a very low power mode. All you need to do is reset the belt warning with the small plug that comes with the quad and your good to go again.
#3
#4
The belt light very seldom means that your belt needs to be replaced. The 100 Hr "Service Belt" reminder is just a recommended inspection of the belt and clutches. I had almost 3,000 miles on my original belt when I sold it and never had one problem with the belt. I had to reset the light several times but it only take 5 minutes to do so. The Arctic Cat and Kawasaki dealers should always have the reset plug in stock. Just to make sure your belt is ok, pull the cover off and make sure the belt is not coming apart or has any threads hanging from it. That's what will "Trip" the safety switch inside the cover.
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
speedbuff
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
13
11-11-2020 10:16 AM
Steeldon
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
09-09-2015 09:38 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)