Pages: 1
Posted by: armoks
Check it again if its clear your good if not make sure the connections are clicked in the whole way. If that don't work get a voltmeter and check the voltage in them using the manuals located here http://www.cannondaleriders.com/tech/index.shtml. if that doesnt work check down inside the connectors to make sure the little tabs arn't bent. hope this helps!
Posted by: WISTECH
If it runs fine and the fault is not consistant it might just be a glitch . I had mine do that once. If it is consistant then check the connectors for damaged , bent pins or corrosion. Quite a few have gotten this code after an engine install. Those little connectors have to be treated with respect. Do not force them on.
Posted by: hakeem
I just got the D&M kit for cannibal and found that I have a "Injector A open fault", any suggestions?
