Pages: 1
Posted by: Sandgod
Try R & S P E R F O R M A N C E . N E T Your motor should still start and at least run.. Look for other problems..
Posted by: WISTECH
I think the most common no start condition after motor install is incorrectly installed ,unplugged,sensorsand fuel injectors. Some connectors will fit in other plugs,please check them,they are labeled. Make sure the pins on the injectors arent bent and you didnt install the battery in backwards. It can and has been done before.Do the obvious first. All grounds connected? Kill switch on? Are the fuel tank fittings firmly connected.
Posted by: ram51
I have a Blaze that has a engine rebuild, had it done, and put the engine back in myself. Now I
can't get it to start, no fuel from the injectors, I don't have the software, cable to diag problem.
Called ATK, they say throttle body has to be calibrated to the injectors?? I live in Indiana and just want to get this quad running so that I can sell it, does anyone know where I could take this Dale to get it fixed?
Anywhere in a 300 mile distance from Indy.
Thanks...
