Pages: 1
Posted by: Bluethumb
If you're looking for a complete exhaust system, an AC aftermarket company makes one. You have to email a contact on their site. Try www.Blackmagicracing.com
Posted by: Bobmack
The new pipe is only 55.00 but, have a muffler shop bend a pipe and put the end on it off your old pipe
Posted by: swampyjunior
The exhaust pipe on my 400i has several large holes rusted through it. I patched it with several sections of muffler tape and some wire but I know its a temporary fix. Since then I have been looking for a new exhaust pipe. Stock AC is a little spendy. The muffler is fine, so I do not need a complete exhaust system.
Does anyone know where I can find an aftermarket exhaust pipe without the muffler?
Also the bike seems to be running a little rich which I think is partly being caused by the holes? I have a dynojet kit but I don't want to mess with putting it in if the exhaust needs to be done as well. Any thoughts or suggestions would be greatly appreciated.
Thanks in advance
SJ
Posted by: swampyjunior
Well I discovered part of the problem was that my muffler is rusted out as well. I just twisted a hole in it trying to get that drain valve off the muffler. Patched it again with more muffler tape.
I was also looking at the part number in my manual for the muffler not the pipe. BUt, I now need a whole new exhaust. I am not sure of the condition of the end off my old pipe so I am not sure if its too far gone to weld.
I found the HMF exhaust and one from White Brother's that should work. Any body have thoughts on either of those or can you point me in another direction?
Thanks
SJ
Posted by: out18law18
u can buy a HMF muffler for a arctic cat 500 and have a muffler shop weld it on. works like a champ.
