Pages: 1
Posted by: Exer_95
I have my arms torn down except for the bearing or bushings, which ever they are.. I can not get the cir-clips out. I was wondering the best means of greasing these things while instaled in the a-arms.. I was considering packing one side, installing the dust seal. Then putting a small amount of mobil 1 into the other end to penetrate the bushing (bearing) itself, then pack that side with grease and install dust seal. Do those steps for the other three locations for each a-arm. Then install a-arm's onto frame..
If you don't think that is a good method, then what is ?? Which type of grease ?? White Litheum ??
I know I am being a pain these last couple days.. I figure everyone understands though.. haha
Thanks
Jason
