Pages: 1
Posted by: propnut
pull the axle off, break the band, completely clean the joint, repack and replace the band. you do not want any water in there and be sure you do not have a tear or hole. axles are not cheap.
and never use a pressure washer to clean an atv (or motorcycle), it just washes out grease and forces water in everything.
Posted by: propnut
my advice is to call a dealer or check someone's online microfiche. I just bought kits as my Arctic Cat was always suffering from ripped boots. I would think yes, but check with your dealer. I'd go the for large band, you should be able to leave the small band on an roll the boot back over it. If it is the inner joint, you may be able to get at it without removing the axle. Good luck.
Posted by: bradgooch
07 Grizzly 660 - Pressure washed it after some mudding and now one of my axle boots looks like a balloon. I assume that it is full of water from the pressure washer. How do I get it out?
Posted by: bradgooch
Can I purchase the band without purchasing the boot? Can I pick this up at the dealer? Thanks for the help.
Posted by: bradgooch
Thanks for the help. I will stop off at my local dealer tomorrow. Thanks again.
