Pages: 1
Posted by: WyoBullRydr
outboard right rear CV boot is torn, think it would work to take 10/12 wraps with the saranwrap and a couple zip ties to secure it for a days riding without destroying the CV joint??
Posted by: WyoBullRydr
Here's the problem with that. I won't have the money for the kit until the end of the month. And, I got so far as the remove the wheel and looked at my grizz and the big @$$ nut holding the hub on the shaft is crimped into the shaft. I tried, and can't get it off. So, I will be forced to pay the dealer the $125.00 to do it. My manual says there is supposed to be a carter pin in there, it's not there, they crimped it at the factory.
Posted by: THECVMAN
You might try stopping by a tire shop or garage and see if you can slip them a few buck or brews to hit it with the air impact wrench. It would be a lot cheaper that $125 bucks to loosen a nut! If you need any pointers PM me.
Posted by: BIGCHEVROLET
its not worth to blow out a hundred dollar joint just to go ride for a day.....get a boot kit tommorow and put it in....unless you wanna risk destroying the joint and dropping quite a few extra bucks down on something that could be easily avoided
Posted by: katman
i had a hell of time getting that off as well ,a huge breaker bar
and anti seeze after that.
Posted by: katman
yea,,,he did use a impact gun on the back, that oll farmer
got every tool made .......dresses like he aint got a pot ta
piss in ........but he can wrench,,,,,,and i learn more about my bike
with each break ......,[knock on wood,i havent had many.}
