Pages: 1
Posted by: markvette
yes it does. the cdi is located under the left front fender. clip the green wire on the cdi and no more rev limiter.
Mark
Posted by: Wkndwaryrs
Does a 2004 90cc Viper have a rev limiter & if so where might it be?? Thanx
Posted by: Wkndwaryrs
Thanx, will try it
Posted by: Wkndwaryrs
ooked for a green wire , but none found. 5 wires total, Black w/white stripe, White w/blue stripe, Black w/ yellow stripe, Black w/ red stripe, & Black solid. Any ideas???
Posted by: Wkndwaryrs
Once again thanx, I found the green wire hidden as you said, seems to make quite an improvement in top end.
Posted by: Scramblur50
Quote
Originally posted by: fishslab
Just bought a '02 Eton 90 Thunder. It is brand new, left over stock at the dealer. Would this apply to it as well?
If it has the green wire, then, yes it would apply. Just akes a few seconds to look for the green wire.
Bryce
Posted by: pigpen
You will need to locate the CDI and remove the rubber sleeve around it. Once you the rubber
sleeve you will see the green wire loop on the back side of the CDI. On the 2004 the CDI is
located on the left side of the bike (if your sitting on it) just inside the body where the steering
column goes in from the handle bars. You can reach you hand down in there and feel it. You can
even pull it up and look at it without taking anything apart. It is a black box about 2"x3"x1".
Posted by: mqr24
we just bought a eton viper 90 2 days ago and the green wire is not a plug in. it's on the backside of the cdi under the mounting rubber . it will open it up when you clip it. hope this helps you out
Posted by: fishslab
Just bought a '02 Eton 90 Thunder. It is brand new, left over stock at the dealer. Would this apply to it as well?
Posted by: HQR109
there is no green wire or rev limiter on the 2000 models. they were choked down by a washer in the head pipe on the exhaust system.
Mark
Posted by: B2base11
I have a 2000 dxl 90 (made by eton) and i can't find the green wire...I took the rubber sleeve off and I could still not find it...and ideas??
Posted by: B2base11
Do you know if that washer is removable...
Thanks
