Below are the steps I use to adjust my clutch. I have had to do this about every other year. Give it a try.
1) locate the clutch adjustment cover. It is an oval shaped cover located on the same side as the shifter.
2) Using an impact driver or large screw driver remove the two screws securing the clutch adjustment cover. Account for the O-ring gasket which usually sticks to the cover.
3) Loosen the jam nuts securing adjustment screw #1 (forward) and screw #2 (rearward).
4) Rotate screw #1 (forward) screw counterclockwise until it stops. It may turn very hard and click.
5) Rotate adjustment screw #2 (rearward) alternately clockwise and counterclockwise to ensure free movement without binding; then lock the jam nut securing adjustment screw #2.
6) Rotate adjustment screw #1 clockwise 1/8 turn then lock its jam nut.
At this point test drive to see if shifts OK. You may need to repeat these steps a couple times to get it adjusted if it is way out.
7) reinstall cover and tighten screws. I also put a little clean oil on the O-ring with my finger before installing it.
Hope this helps and sorry I don't have pictures for you to go with this.
Swampy
|