how to tighten chain on magnum 425
#2
how to tighten chain on magnum 425
if its set up like mi trailblazer u take adn loosen up the front bolt on the bottm of the brake caliper and lossen up the two on teh rear houseing and than put a pin punch in the sprock and when it slides in u move the bike foward or backwoard to tightn it or loosen it
#3
how to tighten chain on magnum 425
Pull the suspension down all the way with a ratchet strap, Loosen two bolts on the axle , insert a punch through the sprocket and into hole in essentric and roll backwards I think, chain should be pretty tight with suspension bottomed out, like 1/8 to 1/4 inch slack.
#6
how to tighten chain on magnum 425
Do as kirbbirds mentioned. WHen I did mine I had little luck the first few tries as well...same story as you. Can't remember if you need to push forward or backwards though?? You should be able to tell which direction to roll the machine. I remember having to roll the machine pretty hard to get the clamps to spin around the axle, the times prior when I couldn't get it to tighten I wasn't rolling the machine hard enough. Give it a good sharp push! Having a extra set of hands to hit the brake to keep the machine from rolling back and loosening the chain back up also helps.
It took me a few learning tries bofere I got it right also, keep trying, it'll go. ANd CRANK those eccentric bolts down tight. I tightened mine down to the 60lbs which was referred to in the book and the chain would loosen on me so crank them TIGHT!
It took me a few learning tries bofere I got it right also, keep trying, it'll go. ANd CRANK those eccentric bolts down tight. I tightened mine down to the 60lbs which was referred to in the book and the chain would loosen on me so crank them TIGHT!
#7
Trending Topics
#9
how to tighten chain on magnum 425
TRY it wit out the ratchet strap maybe when u have it straped down its making it seem like its tight and its really not.....the way i have been told to do it is set on the bike and have some one eles tighting it up so that way ur chain is tight when ur weight is on it i think what is happening is when u have it strapped down ur putting to much weight on it
#10
how to tighten chain on magnum 425
The chain should be "loose" when the ratchet strap is released. The chain tightens when the rear shock is compressed. If the chain is tight when your off the machine, strap undone, you'll break/bend things, chain, sprockets, shafts, etc... So, tighten the chain, when your finished up get behind the machine and hang or push down on the back, you will notice the slack comes out of the chain and it "tightens" the more you compress the suspension. Let up on the suspension and you'll notice the chain "loosen" up. This is the way it should be. If that all makes sense?